濟南防水http://www.lychemical.cn/談到通常情況下，衛生間墻面的防水材料高度要達到30cm在淋浴區，尤其是安裝了花灑的那面墻，防水層最好做足180cm。
Jinan water comes under normal circumstances, the bathroom wall waterproofing material to reach the height of 30cm in the shower area, especially that wall mounted shower, waterproof layer is preferably done 180cm.
  
濟南防水介紹一般來說涂刷的防水層不會影響到墻磚的鋪貼，但如果過于追求防水材料效果而一味地刷，導致防水層過厚，表面過于光滑，那么墻磚的鋪貼就會受到影響。正常情況下，刷2～3遍就可以了，這時墻面上的防水層應該是明顯并且均勻的，個別凸起或凹下去比較嚴重的地方可以重點再涂刷一次，這樣的防水層就能夠滿足使用了，整體的涂刷效果應以不改變墻面凹凸結構為佳。因為只有在毛躁的墻面上，墻磚才能夠牢固地貼在墻上。
Jinan waterproof introduce general brushing waterproof layer does not affect the brick paving, but if too blindly pursue waterproof material effect brush, resulting in a waterproof layer is too thick, the surface is too smooth, then the

brick paving on will be affected. Under normal circumstances, the brush 2 to 3 times on it, then a waterproof layer on the wall should be clear and uniform, individual raised or sunken areas you can focus on more serious brushing once

again, this waterproof layer on can be used to meet the overall brushing effects should not change the structure of the wall is preferably convex. Because only the edgy wall, wall to be able to be firmly attached to the wall.
   
濟南防水http://www.lychemical.cn/談到如果衛生間的墻面本身就過于平整，則可以在做防水之前先用鑿子將墻面拉毛，或者是用水泥和上108膠甩在墻面上，將墻體表面處理毛躁了之后再開始刷。經過這樣的處理，就不用擔心在后期鋪貼墻磚的時候，墻面過于平整而掛不住磚了。
If it comes to Jinan waterproof bathroom wall itself is too smooth, it can be brushed with a chisel to the wall, or is thrown before a waterproof cement and 108 glue on the wall, the wall surface treatment after frizz then began to

brush. After this treatment, do not worry about the time in the late paving tiles, wall tiles up too flat and embarrassing.